With the original series of plants DIMET , which uses gas dynamic spraying of metals method, which is entirely domestic development may quickly and effectively eliminate damage engine components and car bodies, namely the alignment (the metal filling the recesses), the body surface at the junction of parts, dents and other defects, including an aluminum body. Anticorrosion treatment (zinc) of welds and / or points, as well as other local sites the body. Anticorrosion treatment (aluminizing) welds or individual sections of the exhaust tract. Recovery burnout and corrosion gullies in the cylinder head and cylinder block. Restoring a candle carving in the cylinder head. Sealing microleak, small cracks and other defects in the cutting of aluminum, steel, cast iron engine components (cylinder head, cylinder block, covers, housings, gearbox, etc.). Sealing of the tubes, condensers and other parts of car.
Removal of Freon leak in car air. Recovering seats the bearings. Spray brand names or logos, numbers, or check marks, etc. Deposition of copper electrical contact pads. Spray on local sections of cast-iron models (reconstruction, alteration, lapping forms), in foundries (casting into the ground). Restoring gullies on bronze pistons (injection molding). At the core technology is used in installations DIMET Series , is open in the 80s of last century effect, which consists of what is going on consolidation of solid metal particles, which give the supersonic speed at the surface in a collision with her. The technology includes several basic steps – heating the compressed gas (air) supply it in a supersonic nozzle, followed by the formation of a supersonic nozzle in the air stream flow into a stream of powder material (powders also supplied the equipment manufacturer), the acceleration of the material in the nozzle of a supersonic stream of air and directing it to the surface of the workpiece.